Because KrazyGoo is so strong and bonds so fast, some people may find that they have accidentally glued a finger together, or found that that small piece of balsa wood or plastic from a model they were building has completely bonded to their skin!
Not to worry, for even though KrazyGoo is incredibly strong, it has one weakness: K-Y jelly.

K-Y jelly is often found in the medicine cabinet, and a small amount on the end of a Q-tip or cotton swab applied directly to the glue should dissolve the bond without damaging the skin.

Should KrazyGoo bond to any body part where K-Y jelly should not be applied, such as the eyes, the following steps will help you get out of any sticky situation!

+ Skin

Immerse bonded areas in warm, soapy water. Peel or roll skin apart; a spatula or teaspoon handle or even a pencil will help. Remove cured adhesive with warm, soapy water (may take several applications).

+ Lips

If lips are accidentally stuck together, apply a generous amount of warm water and encourage maximum wetting and pressure from saliva from inside the mouth. Peel or roll (do not pull) lips apart. It is almost impossible to swallow the adhesive as a liquid. The adhesive solidifies upon contact with saliva (moisture) and could adhere to the inside of the mouth. Saliva will lift the adhesive in 1-2 days, avoid swallowing the adhesive after detachment.

+ Eyelid

In the event that eyelids are stuck together or bonded to the eyeball, wash thoroughly with warm water and apply a gauze patch. The eye will open without further action within 1-4 days. To our knowledge there has never been a documented case of adhesive in the eye causing permanent damage. Do not try to force eyes open.

+ Eyeball

The adhesive will attach itself to the eye protein and will disassociate from it over time, usually within several hours. Periods of weeping and double vision may be experienced until clearance is achieved. Use of a warmed 3% sodium bicarbonate solution to wash eyes repeatedly may assist in aiding more rapid removal of the adhesive.